Pyramid DC Receiver Installationshandbuch PDF herunterladen (Seite 14)

Page 14

Pyramid Universal Dome Interface Installation Manual

CONNECTING AN AD/SENSORMATIC DOME CAMERA

To connect a Sensormatic dome camera to the UDI, follow the steps below:

CAUTION

When connecting the UDI to a dome, reference should also be made to documentation provided with the dome.

1. Remove the dome assembly from the base. The dome can be connected to the UDI in one of two ways. Connect

the wires to either the I/O board fitted inside the base cover as shown in A - Connecting a Sensormatic dome to the

UDI, or the nine pin connector located on the underside of the dome assembly as shown in B - Connecting and

Configuring a Sensormatic dome.

A - Connecting a Sensormatic dome to the UDI

B - Connecting and configuring a Sensormatic dome

2. The three rotary switches labelled 1, 10 and 100, are used to set the dome address to 1. To do this, set rotary switch

1 to 1, and rotary switches 10 and 100 to 0, as shown in B - Connecting and Configuring a Sensormatic dome.

3. Reconnect the dome assembly to the base.

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 23 24

Keine Kommentare

Pyramid DC Receiver Installationshandbuch Seite 14