Pyramid DC Receiver Installationshandbuch PDF herunterladen (Seite 10)

Page 10

Pyramid Universal Dome Interface Installation Manual

CONNECTING A VICON DOME CAMERA

To connect a Vicon dome camera to the UDI, follow the steps below:

CAUTION

When connecting the UDI to a dome, reference should also be made to documentation provided with the dome.

1. Connect the five-way terminal block on the top of the Vicon dome camera to the wire from the UDIs Dome Data

Connector. Use the diagram below as a guide:

Connecting a Vicon Dome to the UDI

2. On the top of the Vicon dome camera, locate the two blocks of dip switches labelled S1 and S2.

3. On the block of dip switches labelled S2, turn the RS485 and Simplex switches to the ON position as shown

below:

NTSC

VICOA

SIMPL

RS485

OFF

PAL

VPS

UPLEX

RS422

UNIT ADDRESS

S2 S1

White indicate

switch positio

Configuring a Vicon Dome

4. Using the block of dip switches labelled S1, set the dome address to 1. To do this, move the switch labelled 1 to the

ON position and ensure the other seven switches are set to the OFF position. Use the diagram above as a guide.

Note

To use Vicon dome cameras with the UDI, the baud rate of the dome should be set to 4800 baud. This is done

automatically on most Vicon models, including the Surveyor 2000 which has an auto-detect baud rate feature.

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 23 24

Keine Kommentare

Pyramid DC Receiver Installationshandbuch Seite 10