Pyramid DC Receiver Installationshandbuch PDF herunterladen (Seite 12)

Page 12

Pyramid Universal Dome Interface Installation Manual

CONNECTING A JVC DOME CAMERA

3. Locate the rotary address switches and the settings dip switch panel on the dome camera. On the TK-C675, they

are located on the side of the dome camera, while on the TK-C676, they are located on the underside of the top

panel.

4. Using the two rotary switches, set the dome address to 1. To do this, set the right rotary switch to 1, and the left rotary

switch to 0 as shown in the diagram below:

Configuring an JVC Dome

5. Using switch 4 and 5 on the dip switch panel, set the dome camera to Multidrop Simplex mode. To do this, switch

4 should be set to the ON position and switch 5 should also be set to the ON position.

CONNECTING A PELCO DOME CAMERA

To connect a Pelco dome camera (Spectra II model) to the UDI, follow the steps below:

CAUTION

When connecting the UDI to a dome, reference should also be made to documentation provided with the dome.

1. Remove the lower dome and dome drive by aligning and pushing in the coloured tabs. The back box is now

accessible.

2. Open the hinged door to the back box, by pushing the tab lock towards the wall of the unit. The dome PCB will be

visible inside.

3. On the PCB, connect the four-way terminal block to the wire from the UDIs Dome Data Connector. Use the diagram

below as a guide:

RX -

RX +

TX -

TX +

WIRES FROM DOME DATA CONNECTOR ON UDI:

FROM - TERMINAL

FROM + TERMINAL

Connecting a Pelco Dome to the UDI

4. On the top of the dome drive, locate the two blocks of dip switches labelled SW1 and SW2.

5. Using the block of dip switches labelled SW1, set the dome to operate in D-type protocol at 2400 baud. To do

this, move the switch labelled 2 into the ON position and ensure that the other switches are set to the OFF

position, as shown below.

White indicate

switch positio

Configuring a Pelco Dome

6. Using the block of dip switches labelled SW2, set the dome address to 1. To do this, move the switch labelled 1

into the ON position and ensure that the other switches are set to OFF, as shown in the diagram above.

7. Reassemble the dome camera.

Note

The location and numbering of the dip switches may differ between Pelco Spectra II and Spectra III dome cameras.

However, the settings that should be used are consistent from product to product. Consult the Pelco documentation

for more details.

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 23 24

Kommentare zu diesen Handbüchern

Keine Kommentare

Pyramid DC Receiver Installationshandbuch Seite 12

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Empfänger Pyramid DC Receiver