Pyramid 5000+ Betriebsanweisung PDF herunterladen (Seite 13)

AUTO TOTALING TIME CLOCK INSTRUCTIONS

Model 5000

/5000

If time clock prints incomplete characters, the ribbon is not fully installed over

print head. If time clock prints lines that become increasingly light, the cartridge is

not fully snapped into the holder. Reinstall ribbon cartridge, following steps 1-7

until a complete & consistent time card prints.

For assistance, please contact customer support at 888.479.7264 ext 1.

REPLACING RIBBON CARTRIDGE

For optimum performance, the ribbon cartridge should be replaced every 6 months.

To remove old ribbon, lift ribbon cartridge straight up using the tab (B) located

on top of cartridge.

Remove new ribbon cartridge from packaging & turn the manual ribbon advance

knob (D) clockwise to straighten ribbon.

Holding tab, install ribbon cartridge into print carriage, making certain retaining

pins (C) are aligned to rear of carriage clips & ribbon (A) is between print head &

metal print mask (see diagram).

Gently push down cartridge until it snaps into carriage while turning the manual

ribbon advance knob clockwise.

Turn manual ribbon advance knob clockwise a few rotations to ensure ribbon is

positioned correctly in front of print head.

Replace the cover & lock unit.

Feed a time card through unit to test print quality.

A – Ribbon C – Retaining Pins

B – Tab D – Manual Advance Knob

pyramidtimesystem.com

REPLACING RIBBON CARTRIDGE 11

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 19 20

Keine Kommentare

Pyramid 5000+ Betriebsanweisung Seite 13