Pyramid DC Receiver Installationshandbuch PDF herunterladen (Seite 10)

Page 10

Pyramid DC Receiver Installation Manual

CONNECTING THE PAN/TILT HEAD

CON13 provides the power output connections for the Pan/Tilt head. The connections that must be made depend on the

type of Pan/Tilt head used (e.g., 4-wire, 6-wire, 8-wire).

When using an 8-wire Pan/Tilt head, all eight terminals on CON13 will be used (see Figure 8). When using 6-wire Pan/

Tilt heads, only the top six terminals on CON13 will be used, with Pan Brake Return (No.2) and Tilt Brake Return (No.1)

left unused. Similarly with a 4-wire Pan/Tilt head, only the top four terminals will be used.

If necessary, a 7-wire System 7000 Pan/Tilt head can also be used with the DC receiver, but the Pan/Tilt head will require

manufacturer modification beforehand. Contact Baxall Technical Support for more details.

CON13

PAN DRIVE

TILT RETURN

TILT DRIVE

PAN BRAKE

TILT BRAKE

AN BRAKE RETURN

ILT BRAKE RETURN

Figure 8 - CON13 Connections (8-wire P/T head)

CAUTION

The Pan/Tilt head must not draw more than 1A per drive output and 0.25A per brake output or it will damage the DC

receiver.

VIDEO CONNECTIONS

All video must be connected to the receiver PCB via 75 ohm BNC connectors and video coaxial cable. Referring to Figure

2, connect the video from your camera to VIDEO IN and connect VIDEO OUT to the matrix.

Your DC receiver has an on-board video amplifier with gain and lift. Adjustment of gain and lift is done remotely, using a

Pyramid keyboard. For more details on adjusting gain and lift levels, consult the Pyramid 2 Keyboard Operating Manual.

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 19 20

Keine Kommentare

Pyramid DC Receiver Installationshandbuch Seite 10